Rod Holder Single Vert. Railing Single Directional Tilt Assembly 3/4" Dia. to 1 1/8" Dia
SHIPPING INCLUDED TO LOWER 48 STATE DESTINATIONS
MUDDYCREEK Tubes are REMOVABLE – Unlike the other manufacturers who
use thin wall material, saw cut, crimp their tubes permanently on and
add a rubber cap which usually falls off. All of our tubes are heavier
tubing and have a fully machined radius on the end eliminating the need
for a rubber cap, also having a standard right hand thread onto the rod
holder so they can easily be removed whenever necessary. MUDDYCREEK’S
unique system incorporates an O-Ring into the area where the tube
threads on, which compresses and absorbs vibration keeping the tube from
coming loose. This system is great for storage purposes, and for rocket
launchers now able to remove tubes in a few minute, giving you the
clearance under the garage door.
Our High quality rod holders are manufactured in USA.
- Made of air craft quality bright finish anodized aluminum.
- Internal hardware is stainless steel.
- Pivot joint has a boss which fits into a bore on the mating part so the aluminum housing takes the load.
- Both rotational and tilt joints are spring loaded for ease of single hand operation.
- Locks in at every 18 degrees and uses dual pin drive..
